Product Concepts
A starting point for your next custom part. Explore a concept, then share the dimensions and details needed for your project.
Pre-launch concepts — prototype validation pending.
- Base: Three screw-mounted combs up to 100 x 35 x 20 mm
- Options: Channel diameters, spacing and mounting-hole centers
- Includes: Three printed combs (screws/cables excluded)
- Scope: Organization only; no strain-relief claim
Concept illustration
Cable Routing Kit
CCW-101
Material: PETG
$39–$59 per 3-piece kit
Organize the cables behind a workbench or electronics station with spacing sized to your setup.
Concept — prototype pending
- Base: One black bezel up to 200 x 90 x 12 mm
- Options: Switch cutouts, outer dimensions and pattern
- Includes: Printed bezel only (switches/wiring excluded)
- Scope: No waterproof rating or safety-control claim
Concept illustration
Custom Switch Bezel
CCW-102
Material: ASA, planned
$59–$89 per bezel
A faceplate laid out around your accessory switch model and panel opening.
ASA prototype pending
- Base: Body and lid up to 150 x 100 x 60 mm
- Options: Board posts, connector openings and ventilation
- Includes: Printed body and lid only (electronics excluded)
- Scope: Low-voltage indoor use; no IP or safety rating
Concept illustration
Electronics Project Enclosure
CCW-103
Material: PETG
$69–$119 per box and lid
Plan a housing around your board, connectors and access needs.
Concept — prototype pending
- Base: One L-bracket within an 80 x 80 x 80 mm envelope
- Options: Sensor-hole pattern, slot travel and positions
- Includes: Printed bracket only (sensor/fasteners excluded)
- Scope: Non-safety sensing; load and creep require review
Concept illustration
Adjustable Sensor Mount
CCW-104
Material: PETG
$49–$79 per mount
Explore an adjustable mounting position for a small sensor in a bench setup.
Concept — prototype pending
- Base: One organizer up to 180 x 100 x 50 mm
- Options: Tool-hole diameters, spacing and pocket sizes
- Includes: Printed dock only (tools/hardware excluded)
- Scope: Hand tools only; no hot-tool holder claim
Concept illustration
Bench Tool Dock
CCW-105
Material: PETG
$59–$99 per dock
Give the small tools you use most a place on your bench.
Concept — prototype pending
- Base: One nest up to 180 x 120 x 35 mm
- Options: Locating surfaces, hand-access reliefs and mounting
- Includes: Printed nest only (clamps/fasteners excluded)
- Scope: Light manual positioning; no calibrated gauge claim
Concept illustration
Custom Assembly Nest
CCW-106
Material: PETG
$95–$175 per printed nest
Support and locate a small part during light manual assembly.
Concept — prototype pending
Our Process
01
Upload Requirements
Submit your specific CAD data or component goals to begin the build sequence.
02
Engineering Assessment
Carolina Component Works evaluates all specs and constraints to recommend a concept and material set for your project.
03
Final Concept Approval
We review the first sample against agreed fit and function requirements.